aldaytona

Hi All,

Trying to fit a recently purchased upgraded front sway bar on my 66 500. The bar came from P-S-T and is just not fitting right. Anyone out there with any experience with this install?

Cheers,

Aldaytona

 

432bullet

I used a Quickor garage, [ nice part] on mine, i installed it with the eng out and front clip off. I think there some old posts that said they had to drop the lower a arm on one side to get the swabar in ?? Hope this helps

aldaytona

Every piece of info helps. Many thanks

Ggrahn

If you get the front end up, wheel off, you should be able to snake the bar in. I was able to reinstall my factory front bar with almost everything installed. Just takes a little wiggling.

__________________
Gary
66 Custom 500 390

aldaytona

Got it installed, boy that 1-1/8" bar is sure a little heavier than the stock one! Many thanks for your suggestions. Next project the exhaust system...

oneputtster

I know it says don't tighten the end links too much but in my experience you need to tighten them up pretty good to keep them on.

__________________
If you are going through hell, keep going.
Putts drives a black 65 Galaxie 500 4dr. 352, 4100, AC, PS, PDrums, COM transm.