Premier Forums
General Forums
Topic Specific Forums
Model Specific Forums
Classifieds Section
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Latest Posts
-
I'm looking for the York AC compressor mounting brackets for a 66 Galaxie with a 289. I'd love to have any special pulley's to drive the compressor too. Thanks!1 reply 99 views
-
Hello again! I've bought a 65 9 inch from the local junkyard to refresh up and put into my 67 when the engine goes in next month. I'm just curious if I'll be able to reuse the Panhard Bar from the WER axle or if I will have to source one specific to my application. From my understanding 65's...0 replies 2 views
-
Does anybody know if the corners are the same as any other year? I could always weld in new sections from a different year if they fit. thanks.2 replies 67 views
-
I keep reading where this vacuum line coming from the distributor needs to be on a ported side of the carb. Correct me if Im wrong but the port it is on right now is manifold vacuum right? Not sure if The PO connected this right. Im trying to dial in the idle screws with a vacuum gauge and...5 replies 99 views
-
Hello, new to the forum. Finally getting around to paying some attention to my 1968 Galaxie after 20yrs. I’ve kept it running and rebuilt the motor about 6-7years at Survival Motorsports here in MI. I want to start in the cosmetics now and everything else but there’s still a couple things...15 replies 183 views