Ford Muscle Cars Tech Forum banner
Discussions
About
Our Top Forums Full Forum Listing →

All Ford Techboard

Technical discussion for all Ford makes and models.
  • 304K
  • 91.1M
  • 304K
  • 91.1M

Galaxie Pages

Discussion specific to the Ford Galaxie.
  • 189K
  • 36.8M
  • 189K
  • 36.8M

The Garage

Non-tech discussion.
  • 179K
  • 20.4M
  • 179K
  • 20.4M

Falcon Pages

Discussions specific to the Ford Falcon or Mercury Comet.
  • 41.2K
  • 11.7M
  • 41.2K
  • 11.7M

Mustang Pages (1965-1973)

Discussion specific to early Mustangs.
  • 27K
  • 8.6M
  • 27K
  • 8.6M
Top Photos Go to Showcase →
Thunderbolt
Thunderbolt 1964 Ford thunderbol...
Sfm5r530
1965 Afx comet cyclone
1965 Afx comet cyclone Afx factory race car...
Sfm5r530
Galaxie lightweight
Galaxie lightweight 1962 Galaxie lightwe...
Sfm5r530
R model Shelby mustang
R model Shelby mustang 1965 Shelby rmodel
Sfm5r530
Trending Discussions All Trending Discussions →
  1. Post Pics of your Galaxies

    Galaxie Pages
    1968
  2. Ticking Noise

    Galaxie Pages
    Hi All, My 2nd post here. You all were so helpful with my 1st that this was the first place I had to ask this new question lol. So i have a 1965 Galaxie 500 w/ 352 that i just pulled and rebuilt as a learning experiment. It seems to be running pretty well, but i'm having one issue that i...
  3. has anyone tubbed a full size galaxie

    Galaxie Pages
    I have a 67 custom 62b and it has a 545 blown fuel injected motor and custom trans, I have a tds 6061 (' with 31"x 17.5 tires ladder bars coil overs has anyone tubbed one of these galaxies and if so can you provide some guidance
  4. The Great Ms. American 3.14159 Chase Truck Renovation Caper

    Galaxie Pages
    Hey All, Because of logistics brought on by such things as weather, and other considerations, I'm going to start this new thread, not so much as a Ms. American specific discussion, but more as a "General Mechanical Knowledge" kind of thing. This is NOT to turn the FM Forum into a discussion...
  5. Pertronix: should it be run on the resistor wire or switched 12V?

    Galaxie Pages
    This may be a stupid question but I found the instructions a bit vague on this. I've been running the resistor wire on my 65 to the coil. I have the Pertronix module in the distributor. Engine starts easily and runs very nicely but should I be running the coil on a 12V source? Sent from...
Top