Join Date: Oct 2010
Location: San Francisco .Calif
Re: Need help with yoke identification
Are you saying that I should find a yoke that bolts to that round flange on the diff as long as it matches the size of the u-joint on the driveshaft?
because the odds is that you will over/under torque nut ....mess up crush sleeve
let say that if you where only to replace oil seal..no problem
then you just mark nut and yoke, count turns while removing nut..
then when installing same amount of turns ..
on final turn, land exactly on mark on yoke and not going past.....
64 galaxie 500 2dr fastback...390 4v, Bendtsen adapter, maddog's stage3 700R4 trans,3.70 Posi..far from perfect but getting there...