Ford Muscle Forums : Ford Muscle Cars Tech Forum - View Profile: 63ford406

63ford406 63ford406 is offline

Registered User

  Visitor Messages

Showing Visitor Messages 1 to 9 of 9
  1. POPS 64
    03-24-2015 11:17 AM - permalink
    POPS 64
    You mentioned you knew of two Ford mechanics one in Alhambra the other Orange. Can you forward that info to me. Much appreciated.
  2. 63ford406
    04-30-2013 08:33 PM - permalink
    63ford406
    djimbeau, you might have a c-6 check the pan shape
  3. djimbeau
    04-30-2013 07:28 PM - permalink
    djimbeau
    hello 63ford406, ive read some posts about trannys for a galaxy and tatabout what i need a rebuild or tranny,and im tryn to figure out what tranny i have and found some conflicting info.http://www.crankshaftcoalition.com/w...ation#Preamble this site says if i have a 390 then its iron cast and mines aluminum... and its a 3 speed but it wont stick to a magnet. i just wanna ask you what will bolt up to a 390 and do i have any options like aod maybe. anyways thanks for youre time
  4. 64galaxieXLvrt
    02-23-2013 07:56 PM - permalink
    64galaxieXLvrt
    Hey how are ya? Seen your post about AM/FM in a 64 galaxie vert
    I also have a 64 gal convertable that I am putting an FM in, I have the F4TBF corect Bendix radio and faceplate! could you send the link passed along to you?
  5. 63.5xl
    11-02-2012 07:26 AM - permalink
    63.5xl
    Hi 63Ford406,
    How much for your clutch pedal setup, I am looking for the later bell housing, I understand if I want to put a T5 or Tkko or the later toploader I would need the later bell housing. Does that sound right to you
    Carl My email is [email protected]
  6. lagalaxie500
    05-07-2012 02:21 PM - permalink
    lagalaxie500
    What you asking for it? It want make the alternator stick up above the valve cover will it? I'm gona have to move the raidator tank so I can install the HEI dist.
  7. Mike Ragan
    06-11-2011 03:21 PM - permalink
    Mike Ragan
    Hey! Thanks for the response. My email is [email protected].

    Thanks!
  8. cattmann
    04-01-2011 01:31 PM - permalink
    cattmann
    ok its [email protected] thanks again
  9. Dingus McGee
    10-27-2010 08:23 AM - permalink
    Dingus McGee
    I'm back. I bought the tailshaft housing from you a few months ago. I need 4 hi-po 15 x 5-1/2 steel wheels for the resto.
    If you can help, or know someone that can help me, let me know.
    Skip at [email protected].
    Thanks.

  About Me

  • Signature
    Ford Galaxie Club of America #665
    So-Cal Galaxies

  Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 12-11-2018 02:38 PM
  • Join Date: 10-15-2003
  • Referrals: 0

  Friends

Showing Friends 1 to 2 of 2
  • kfactor90
    • kfactor90 is offline
  • NavyLDO
    • NavyLDO is offline

  Mentions

No results to display...

  Quotes

09-19-2018
06:06 AM - Jiffy quoted 63ford406 in post Re: Is it possible to remove a '63 dash pad and leave gauges in situ?
There’s a full metal dash unde...
09-17-2018
05:29 AM - lgh1157 quoted 63ford406 in post Re: 1961-63 bumper Guards fitment
Johan, Rear guards will work. ...
08-08-2018
05:24 AM - lgh1157 quoted 63ford406 in post Re: 63 Fastback Windshield
Fastback windshields are the s...
09-13-2017
06:52 PM - BC_99 quoted 63ford406 in post Re: A few more questions concerning my 64.
I'm going to tell you if you p...
09-10-2017
05:49 PM - BC_99 quoted 63ford406 in post Re: A few more questions concerning my 64.
Reseal the pump. You can do it...
07-27-2017
01:55 AM - ShotRod64 quoted 63ford406 in post Re: 1964 stock steel rims question
Thanks Richard! Seems everyth...
07-14-2017
06:02 PM - SanDogDewey quoted 63ford406 in post Re: Generator vs. Alternator
But they don't charge at idle ...
06-22-2017
03:30 PM - koosh351 quoted 63ford406 in post Re: What colour is brake light wire?
Do you know where the master c...
06-20-2017
05:30 PM - RAGGAREN quoted 63ford406 in post Re: What colour is brake light wire?
Do you know where the master c...
06-19-2017
10:02 PM - battleship quoted 63ford406 in post Re: What colour is brake light wire?
The switch is on the master cy...
06-08-2017
06:47 AM - Lowrider quoted 63ford406 in post Re: Ignition Switch help
Lowrider is right. In 69 Ford ...
05-03-2017
07:55 AM - DesertXL quoted 63ford406 in post Re: Clutch pedal setup for 1967
One on Epay right now. Bloody...
05-01-2017
02:18 PM - Mr. Spock quoted 63ford406 in post Re: Stock Generator 63 Galaxie
If everything is working right...
04-21-2017
05:20 AM - lgh1157 quoted 63ford406 in post Re: WTB - 63 tail light bucket and trunk trim
L, I have both buckets and the...
07-18-2016
11:45 PM - ShotRod64 quoted 63ford406 in post Re: After 12 yrs Finally Got the Quarter on
PM on it's way Richard I ha...
07-14-2016
01:20 AM - ShotRod64 quoted 63ford406 in post Re: After 12 yrs Finally Got the Quarter on
It sure has! Time flies doesn...
06-15-2016
02:57 PM - 63.5xl quoted 63ford406 in post Re: 63 Steering Stops
[quote=63ford406;2515905]Check with D...
02:52 PM - 63.5xl quoted 63ford406 in post Re: 63 front tires: How big? Steering stops?
I don't have a picture. But le...
06-14-2016
07:18 PM - 63.5xl quoted 63ford406 in post Re: 63 front tires: How big? Steering stops?
Like I replied to you before c...
05-27-2016
03:04 PM - 1964Fastback quoted 63ford406 in post Re: 1964 power drum to manual drum brake conversion
Pedal is the same. I have a 64...
 
For the best viewing experience please update your browser to Google Chrome