Ford Muscle Forums : Ford Muscle Cars Tech Forum - Reply to Topic
Thread: Thoughts on header wrap Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Ford Muscle Forums : Ford Muscle Cars Tech Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
06-30-2014 03:22 PM
David F.
Re: Thoughts on header wrap

I worked as a muffler man for over 20 years and never used header wrap. I worked on 5 or 6 cars and trucks with wrapped headers for exhaust leaks at the headers. When we removed the header wrap from the header the tubes were crystallized from excessive heat. Looked like they came out of a blast furnace with all the carbon burned off. If you tapped them with a hammer they would crumble at that spot. Because of this I never recommend header wrap. One header was only about a year old. The worst headers came off a motor home, the more load an engine has the hotter it runs. Gary
06-30-2014 12:46 PM
barnett468
Re: Thoughts on header wrap

Quote:
Originally Posted by roger View Post
Barnett- I should have been more specific, solenoid will click, but she won't turn over, until cooled down, then starts, first crank & runs just fine.
Yesterday I pulled the mini starter, covered it with this hi-temp covering I got from the Subaru boys, supposedly reflects 85-90% radiant heat.
Went on a run last night, it was 90 out, & 2 stops, she started right up.
Now, she hasn't done this non turn over thing at every stop, so I won't say its all good for a few more runs yet!
hello;

if it happens take a battery jumper cable and jump the front solenoid post to the rear post. if it turns over your solenoid is bad.

you can also put some lava wrap on the headers in the starter area to reduce temps by the starter even further.
06-30-2014 08:49 AM
roger
Re: Thoughts on header wrap

Barnett- I should have been more specific, solenoid will click, but she won't turn over, until cooled down, then starts, first crank & runs just fine.
Yesterday I pulled the mini starter, covered it with this hi-temp covering I got from the Subaru boys, supposedly reflects 85-90% radiant heat.
Went on a run last night, it was 90 out, & 2 stops, she started right up.
Now, she hasn't done this non turn over thing at every stop, so I won't say its all good for a few more runs yet!
06-28-2014 03:59 PM
barnett468
Re: Thoughts on header wrap

Quote:
Originally Posted by roger View Post
i;m running long tube headers on my 347 in a 62 f;lane. I didn't order them coated mainly because i knew we had to "re-arrange" a couple of tubes, 1- to clear steering rack, 2- to clear bellhousing, so i sprayed em with eastwoods hi-heat header paint. Other than protection from the elements i doubt the paint helps in lowering underhood temps, to any degree.,
which brings me to my question - does header wrap really help reduce underhood heat, enough to warrant using it?
My son used wrap on his subaru headers, which, by the way, were ungodly expensive (syms) & then sprayed the wrap with this - dei- hi-temp silicone coating, which supposedly seals & protects the wrap. The spray certainly dried into a tough, hard coating.
I ask because i think underhood heat is a major factor in hot start issues, if i wait 1/2 hr. She turns over & starts, no problem.
Thanks
hot start probs are typically, timing, too high of a float level, weak starter and/or insufficient cooling system.

The header wrap will reduce temps but it will not fix your probs. The lava wrap is popular and does not require sealer.
06-28-2014 09:06 AM
roger
Thoughts on header wrap

I;m running long tube headers on my 347 in a 62 F;lane. I didn't order them coated mainly because I knew we had to "re-arrange" a couple of tubes, 1- to clear steering rack, 2- to clear bellhousing, so I sprayed em with Eastwoods Hi-heat header paint. Other than protection from the elements I doubt the paint helps in lowering underhood temps, to any degree.,
Which brings me to my question - Does header wrap really help reduce underhood heat, enough to warrant using it?
My son used wrap on his Subaru headers, which, by the way, were ungodly expensive (Syms) & then sprayed the wrap with this - DEI- Hi-temp silicone coating, which supposedly seals & protects the wrap. The spray certainly dried into a tough, hard coating.
I ask because I think underhood heat is a major factor in hot start issues, if I wait 1/2 hr. she turns over & starts, no problem.
thanks

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome