ford falcon

Hi everyone, I’m new to the forum and I will like to know what is the max width I can run in the Falcon without any modifications... I am will like to use some 15x10 on rear if possible...

ive recently replaced my valve cover gasket, ignition coil, all plugs and plug wires, the dist cap and starter it self, the engine is a line 6 170 2 speed automatic tranny. withing the passed week ive had the car in a shop due to shredded flywheel teeth, so after i got the ring of teetha nd took...

So I have a 1965 Falcon 2dr with a 170 I6. I have a decided to swap a 351w from a 93 Bronco (converted back to Carb). I'm a little confused about what bell housing I need since I have 164t flywheel. Any help would be much appreciated.

I am looking to get new rims for my 1964 Falcon Sprint. Would 15"x7" rims with 215/60/15 for the front and 225/60/15 for the back work? I have disk brakes from a Grenada in the front. If this works, what off sets would I want?

I bought my 64 Falcon in pieces 15 years ago. Now that I am putting it back together, I cannot figure out what goes below the rear quarter window and above the chrome door panel trim on the interior. Can some one show me some photos or recommend where I could find these pieces?