Search Results for ‘toploader’

I replaced my clutch and when I put my transmission back In the transmission ran terribly for 2 days until it completely binded and now I’m stuck in second gear. Any idea where I went wrong or how to fix?

Hi all, I have a 69 Cougar with a 351W and currently have a 3speed toploader in it. Ive seen alot of T5 conversions but there is alot of confusion as well (for the '69s and 70's particularly). I am hoping to get your help to clear my confusion. 1. I have a 164 tooth flywheel and the...

So this is my first rebuild of my low milage 65 toploader, which has been leaking, and I have a few questions. It appears much of my leaking originated from the top cover vent, which had the proper gasket installed in the correct orientation. However, I already have a tail housing vent so I...

What would I need to do to swap a c4 to a 4 speed toploader in a 1966 ford fairlane what modifications to the body would need to be done to do so? Is there brackets for the clutch pedal and would i have to modify the body at all? Thank You!

Hi, I have been daily driving my 1964 Ranchero 260 v8 3 on the tree for about 5 months now, and as the summer in colorado approaches I will be making more frequent trips through the mountains and on highways and the lack of gearing in the 3 speed is beginning to limit My Ranchero's usability...

I am installing a toploader 4 speed and a 351c in a 68 fairlane. I have found a billet flywheel and a centerforce 11" clutch setup for my tranny. Now i have to figure a way to activate my clutch. I have seen some setups that are cable and some that are hydraulic. I dunno which way to go and what...

Greetings! I'm having problems with my cluth pedal. Although the engine/transmission/pressure plate and clutch are all fairly "new" (less than 10,000 very easy miles), the amount of "pedal" available has dropped to just a couple of inches off of the floorboard. It's a 63 galaxie that was...

I have a really nice top loader, 28 spline, close ratio, that came out of a running 1970 Torino, 351 car. I also have the original Torino Hurst shifter, (linkage still on the tranny) with rubber boot and back up light switch! Chrome is really, really nice! Also have the four speed "hump? Total...

Hi all, Due to a number of reasons, I had to make the decision to sell my Cobra project. Before I list it on CraigsList and eBay tomorrow, I thought I would check here first to see if anyone was interested. Here is a quick rundown: 1969 R-code Cobra Fastback, 428 SCJ Drag-pack, (4.30...

I've just bought a 1964 Ford Toploader close-ratio 4-speed (as seen in the Fairlane hi-po and Sunbeam Tiger) and have been digging into what would be needed to install it into my 1962 Ford Fairlane. Besides the transmission itself, the hardest piece I've been trying to track down is a Hurst...

I've just bought a 1964 Ford Toploader close-ratio 4-speed (as seen in the Fairlane hi-po and Sunbeam Tiger) and have been digging into what would be needed to install it into my 1962 Ford Fairlane. Besides the transmission itself, the hardest piece I've been trying to track down is a Hurst...