2 wire vs 3 wire Fuel Tank Sending Units
1 - 2 of 2 Posts
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
under dash
Galaxie Pageslately ive seen alot about working under dashboards. if you don't have one of these, make one your back will thank you- 0
- 0
-
Pertronix: should it be run on the resistor wire or switched 12V?
Galaxie PagesThis may be a stupid question but I found the instructions a bit vague on this. I've been running the resistor wire on my 65 to the coil. I have the Pertronix module in the distributor. Engine starts easily and runs very nicely but should I be running the coil on a 12V source? Sent from...- 77
- 34K
-
Under Dash Electrical - What is it?
Galaxie PagesSo I am starting working on troubleshooting some interior electrical components, namely the clock, which was a recent quartz conversion, and the light for the glove compartment. The glove compartment light seems to be an easy one, it was not connected at all. Is this an ignition on accessory...- 15
- 259
-
New Guy
Galaxie PagesNew here, not new to fixing and rebuilding, restoring ,cars, trucks, motorcycles. I recently purchased a 1966 Galaxie. Im sure I will get some pics up soon, i am in process of putting it all back together. Most stuff is nothing new but i have a few parts that were in the many totes that i need...- 4
- 156
-
Yard Farmer · updated
-
63.5 Speedo issues won't go away - anyone have aT-10 car?
Galaxie PagesHere is a pic of my speed cable that inserts into the tailshaft housing - can someone verify that this is correct and the same as theirs? Best I can detect is that this isn't even touching the gear on the output shaft when the tailshaft is in motion. With the engine off, and the cable removed...- 18
- 477
Join now to ask and comment!