Ford Muscle Cars Tech Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,425 Posts
On 2006-02-23 16:43, mavman wrote:
The D3's are too, but they need to be machined to accept the screw-in studs & guideplates.
I beg to differ on this. I use a set of D3's and I beleve it was comp cams that had a stud and guideplate kit that just bolts on to the D3 head.. Its been working fine for 3yrs now.. I did have to use Mr. Gasket poly-locks as the others had to big a head on the nut and the nut would hit the roller tip rockers leaving a valve open and bending the stud.
tim
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top