Ball Milled FE-390 Valve Covers Needed

1 - 1 of 1 Posts

Dave's Garage

Registered

Joined Apr 4, 2013

5 Posts

Discussion Starter • #1 • Feb 3, 2018

Good Day,

I'm trying to locate a set of ball milled aluminum valve covers to fit an FE project we're working on.

$$ in hand, let me know what you got laying around.

Thanks,
Dave

1 - 1 of 1 Posts

Recommended Reading

wanted engine perches

Engine

I'm looking for engine perches to fit a 71 Ranchero to swap from a i6 to 351c v8
- 0
- 38
- F
  fatguy · updated 4 d ago
352 Fully Machined, Custom Made Parts, Intended for High Horsepower Application

Engine

352 FE fully machined with ground, polished and balanced crankshaft, custom machined Diamond pistons, Total Seal gapless rings, completely ported and polished heads with custom Ferrea stainless undercut valves and hardened seats. Plus an extra set of 1968 Ford 390 FE heads. This was for a build...
- 1
- 126
- DesertXL · updated 10 d ago
Supercharger for 351C???

Engine

I have a 351 Cleveland and I was throwing up some different ideas for future plans on my car and had thought about adding a supercharger. Does anyone know what size, type, brand, cost, etc, supercharger would fit on a 351?
- 3
- 345
- Youngbuck_mech · updated 1 mo ago
1969 Stang, Complete 351W, bellhousing, 4Spd

Engine

I have come into possession of a 351W (2V), 4 spd (with ID Tag) power train. This is complete from output shaft of the 4 spd, including all the Ford factory stamped with Ford part #s shifter/shifter arm and linkage. Bellhousing (case iron with fork), (clutch/PP/Flywhl), and the engine from the...
- 2
- 261
- R
  rickyracer1983 · updated 2 mo ago
World Products Heads

Engine

I have a Pr of World Products heads with Manley 2.00int and 1.60exh valves that have about 250 miles on them before I received them. I disassembled them cleaned and had the valves redone along with JUST surfaced. Heads CCed at 61.5cc. Installed new rubber valve seals, and Crane dual springs...
- 0
- 100
- R
  rickyracer1983 · updated 2 mo ago