Ford Muscle Cars Tech Forum banner

1 - 16 of 16 Posts

·
Banned
Joined
·
6,355 Posts
Discussion Starter · #1 · (Edited)
new set of Boss 302 flat tops .030 over with rings $395

used set of Boss302 dome pistons by TRW . .030 over

289 HiPo con. rods , comes with package of aftermarket bolts ..
yes these are hipo's with 3/8" bolts rods . $198

also have used TRW 302 (non Boss) flat tops on aftermarket rods(3/8).
comes with new set of file fit piston rings P & R's are .030 over $335

ALL pistons listed are Forged

plus shipping cost by USPS or FedEx
 

·
Registered
Joined
·
1 Posts
new set of Boss 302 flat tops .030 over with rings $395

used set of Boss302 dome pistons by TRW . .030 over

289 HiPo con. rods , comes with package of aftermarket bolts ..
yes these are hipo's with 3/8" bolts rods . $198

also have used TRW 302 (non Boss) flat tops on aftermarket rods(3/8).
comes with new set of file fit piston rings P & R's are .030 over $335

ALL pistons listed are Forged

plus shipping cost by USPS or FedEx
Can you email me your phone number interested in your parts
Please email to [email protected]
I don't check this much
 

·
Registered
Joined
·
62 Posts
DanH: I bought the B302 offy tunnel ram top from you a while back . I picked up a set of 351c 4v CC heads and was wondering if you have an estimate of the CR with my heads if I was to use the flat tops you have for sale.
 

·
Banned
Joined
·
6,355 Posts
Discussion Starter · #6 ·
62cc chamber
.040" gasket
zero deck
----------> 9.5 to 1 C/R
 

·
Banned
Joined
·
6,355 Posts
Discussion Starter · #8 ·
most likely will have them . for some reason , those that pm , don't want to give a phone number
 

·
Registered
Joined
·
62 Posts
I'll check back in a few weeks when I have the cash to see if you still have the parts.

You wouldn't happen to have or know where I could get a Roush B302 single plane intake?

Looking for the version with the water cross-over built in:



 

·
Banned
Joined
·
6,355 Posts
Discussion Starter · #10 ·
no idea where to get one , say that would be a rare intake to find
 

·
Registered
Joined
·
674 Posts
Thinking the B version is the raised port one for Yates heads. They quit making the stock port location loooooooog ago. They taked about making the older version. Bugged them about it for months wanted one for my Bosss 302. Finaly got them to admit the used the old casting pattern to make the raised port intake and didnt want to spend the money for newer equipment. The Yartes version can be machined to fit factory heads but many areas are paper thin.
 

·
Banned
Joined
·
6,355 Posts
Discussion Starter · #15 ·
Boss302 flat tops and 289 HiPo rods sold
 
1 - 16 of 16 Posts
Top