c4 74-76

1142 Views 5 Replies 3 Participants Last post by SLOWJOE, Mar 8, 2006

SLOWJOE

Discussion Starter · Mar 6, 2006

Not sure which year i cleaned the whole tranny up put new stuff in and put it all back together, yet i'm having a problem, i don't know if i put the linkage inside wrong but i can't get the parking pawl to disengauge when i move the shifter. I opened it up and played with it and I can see it not disengaging. but when i push the that think on the spring in the back down it allows the shaft to turn. anybody have any diagrams on how this linkage goes inside? it a manual valve body so i removed the kick down linkage

Save

1 - 6 of 6 Posts

Freddie

· #2 · Mar 6, 2006

Try this link, it has the most complete set of photos I have seen anywhere.

http://www.vintagebronco.com/bwickert/C4Rebuild/

Save

SLOWJOE

Discussion Starter · #3 · Mar 7, 2006

THANKS!

Save

ZephyrZ7

· #4 · Mar 7, 2006

I think this is specifically what you want to see....

http://www.vintagebronco.com/bwickert/C4Rebuild/Linkage1.JPG
_________________
There is a fine line between a hobby.... and mental illness.

<font size=-1>[ This Message was edited by: ZephyrZ7 on 3/7/06 10:42pm ]</font>

See less See more

Save

ZephyrZ7

· #5 · Mar 7, 2006

here's a picture of mine, I also used a manual valve body, nevermind the "notes" I had sent this pic to a friend of mine a while back...

_________________
There is a fine line between a hobby.... and mental illness.

<font size=-1>[ This Message was edited by: ZephyrZ7 on 3/7/06 10:42pm ]</font>

See less See more

Save

SLOWJOE

Discussion Starter · #6 · Mar 8, 2006

YUP i had it wrong it's working now thanks!

Save

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month