Ford Muscle Cars Tech Forum banner
1 - 1 of 1 Posts

· Premium Member
Joined
·
1,455 Posts
If installed correctly the TQ converter should be loose in the flywheel. Meaning its not in a bind. Did you check before installing trans that pilot on the TQ converter would fit the hole on the crankshaft ok? Did you make sure the hole in crankshaft didn't have an old pilot bearing left in it? If the TQ converter is up against the flywheel in a bind then the TQ isn't properly seated in the trans.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top