Ford Muscle Cars Tech Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
10 Posts
Hello ,
I dont mean to butt in ... but ... I have an issue .
I have a 68 302 and a 74 c4 transmission ( not original to this car ) a new 157 tooth flex plate , new spacer plate .
When I tried to aline everything , my starter wont bolt to the bell . the bolt holes dont line up.name says... very green , this is my first project . can anyone tell me whats wrong ... besides the fact that I don't know what I am doing.
like my
 

· Registered
Joined
·
10 Posts
thank you for taking the time to respond ,

the transmission is new to the car , I send my old one out to be reworked and they lost, misplaced or sold it and I was given this one by the shop owner. according to him it is a better trans than my original.
everything matches , bolt wise except the starter to the bell.
if you were to take the bell out of the mix everything lines up - spacer plate , starter to crank . the spacer plate seems to be smaller than the bell.

thanks again
David
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top