[pmoylan]

Hi all,just wondering if anyone here has had a chance to test the various alloy heads available for the mighty 351 cleveland,i know of svo,edelbrock,3v pavtek,and airflow research,which is the best head?i have flow figures for the 3v only,and want to compere all heads before buying a set,with a funnelweb intake and roller set up i'm looking for 650+h/p,can anyone offer some advice??

 

[tonys10sec306]

The 3v looks like a very good heads.I havent heard much about edelbrocks heads. http://mpgheads.com/ check them out they made almost 700hp with a set

 

[dfree383]

Friend of mine just Got a Set of the 3V's and flowed them on his bench. They where a little bit disapointing out of the box considering the bare cost. But The Brodix ones are quite impressive......

 

[sharpshot71]

I have heard that the Edlebrocks are overpriced for their flow #s. I think i have seen on this site that they flow only slightly better then the stock port aussie heads. dont take that for fact. Maybe try a forum search???

 

[kid vishus]

The edelcrock heads are way over priced for what you get. And that is a nice combustion chamber, heads cast from aluminum, and ports that barely flow more than well ported 2v heads.

Air Flow Research does not make cleveland heads. Air Flow Dynamics does. http://www.airflowdynamics.com.au
They are the best of the bunch that dont cost an arm and a leg. Out of the box they flow better than the CHI heads. CHI heads are good heads also.

But in my opinion, they all are over rated. My 35 yr old iron heads flow more than all of those do.

<font size=-1>[ This Message was edited by: kid vishus on 2/23/06 8:02am ]</font>