Ford Muscle Cars Tech Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Anyone out there have any tips on this? I know edlebrock makes a 5.8L manifold they say will flow enough air for a 428, but what about other parts? Any ideas would be great!
 

·
Registered
Joined
·
1,105 Posts
Go to the Network54 boards, and type in FE Big Block under the search option. Go to the 78142, or something like that board, its the good one. They'll tell you to search back some pages, but they have a few memebers with EFI set-ups on the FE's, not the 5.8 manifold, its much too narrow to be able to fit between the heads on an FE. Good luck
 

·
Registered
Joined
·
7 Posts
Discussion Starter #3
Yes, I'm speaking of a 351W stroked out to 428ci. I've checked out the edlebrock manifold and it looks to be a likely candidate. What about other EFI parts: Injectors, mass air meter, computer, etc? So far my experience with EFI consits of throwing parts over my shoulder as I make room for a carb.
Thanks again!!
 
1 - 4 of 4 Posts
Top