Ford Muscle Cars Tech Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Rebuilt 260 cid engine in my mustang and I Bore 3.840 "(+0.040"). I was looking for a Head Gasket I bought the 260 Engine Gasket Kit and it is 4.00 ". 3.840 but I need." I do not know where to buy or ordered all the 260,289,302 mark, and it is 4.00 ", I'm from Europe and my friend is google translator.....any ideas?

Thank you
 

·
Registered
Joined
·
489 Posts
At 0.040" overbore you are experiencing a total bore size of 3.88". That is only 0.06" EACH side. No problem. Just make certain that the water cooling holes are lined up. Best regards. John--Las Vegas.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #5
At 0.040" overbore you are experiencing a total bore size of 3.88". That is only 0.06" EACH side. No problem. Just make certain that the water cooling holes are lined up. Best regards. John--Las Vegas.
Thank you very much
 
1 - 7 of 7 Posts
Top