Ford Muscle Cars Tech Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
I have the following parts from a 1968 Fairlane - 289, C4, flexplate, 2100, fuel pump, carb spacer. I also have the following parts from a 2000 F-250 - bedliner, track bar, outer front axle shafts, front wheel bearings, 10.5" 3 pinion limited slip differential. Make offers.
 

·
Registered
Joined
·
16 Posts
Discussion Starter #4
Yes Autolite 2100 2 barrel carburetor. Came out of a 68 Fairlane. I will get casting numbers off it and try to get all the specifications you need.
 

·
Registered
Joined
·
16 Posts
Discussion Starter #6
I'm sorry for taking so long but I have been extremely busy the past 2 weeks. Yes you are looking for the venturi size correct? 1.08in. Well I have not measured but 108 is cast in the left hand carburetor body.
 

·
Registered
Joined
·
97 Posts
Hello

Bummer, I need a least 1.21, 1.23. Hoped it was a 1.33

This will be used on a stock car.

My current 1.23 goes lean over 5000rpm.

#12
 

·
Registered
Joined
·
16 Posts
Discussion Starter #8
I got ya. Ok you need a big block 2 barrel then. This came off a 289. If I come across one I will let you know. Thanks for the interest though.
 

·
Registered
Joined
·
16 Posts
Discussion Starter #12
From a 2001 F350 - frame, front/rear driveshafts, 5.4L 2V, 4R100/NP271, fuel tank, starter, air intake, overload springs, wiring harnesses
 

·
Registered
Joined
·
16 Posts
Discussion Starter #14
Also have condenser, power steering cooler/reservoir, transmission cooler, radiator, charcoal canister, HCU, cruise servo, HVAC cases, PCM, brake pedal, vacuum booster/master cylinder, throttle pedal, dashboard, shift cable, throttle cable, leather seats.
 
1 - 14 of 14 Posts
Top