Ford Muscle Cars Tech Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6,662 Posts
These are about as good as it gets for stock vintage small block heads.60.4cc chambers 1.84 intake valve 1.54 exhaust.
I assume were talking windsors here

<font size=-1>[ This Message was edited by: frdnut on 3/23/02 10:30am ]</font>
 

·
Registered
Joined
·
38 Posts
Discussion Starter #3
they are windsors, I was thinking of porting them myself and have a machine shop set them up for guide plates and roller rockers, work the valves[stainless and increase size] and chambers.
how much do you think that would cost and how would they flow
thanks
ron
 

·
Registered
Joined
·
131 Posts
just buy a set of roush heads and touch them up a bit and you will have a really good set of heads ready to go.
 
1 - 4 of 4 Posts
Top