Ford Muscle Cars Tech Forum banner
1 - 3 of 3 Posts

· Registered
657 Posts
Discussion Starter · #1 ·
I was just wondering if there is a reason my head gaskets have small holes where the water passages are. (much smaller than the passage)

Would it help to "match" the gaskets to the block and head water passages?

I'm guessing they are made this way for a reason... but still wondering.

These are the "stock" sbf heads gaskets.

Anyone notice this before?
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.