Ford Muscle Cars Tech Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,635 Posts
Discussion Starter #1
HELP, I have a hurst billet shifter in my '65 stang and the hurst B-4 shifter boot is to small at 3.5 X 4.5 .Hurst does make a super boot but it is at 7.750 X 8.750. QUESTION is have you been down this road before and is there a boot in between those two sizes made by anyone.PLEASE advise and thank you for your help.
 

·
Registered
Joined
·
75 Posts
Been down that road a couple of times. Had trouble with the rubber one tearing,both stock and aftermarket. Finally went to an upholstry shop. They made me one out of leather. It was cheaper than a rubber one and looks much better. That was 6 years ago and still looks great. Just find the metal hold down piece where it bolts to the floor.
 

·
Registered
Joined
·
3,700 Posts
Yeap ... I make my own out of leather


I made the one in my Mach1 about five years ago ... just rub it down with a little leather conditioner occasionally and it looks and stays great.

In fact I'm just about ready to make one for Queenie's 67 Camaro ... damn rubber one is ripping apart after only about a year of use.


_________________

Larry Madsen
Las Vegas Nevada



<font size=-1>[ This Message was edited by: monstermach on 5/2/03 1:21pm ]</font>
 

·
Registered
Joined
·
1,635 Posts
Discussion Starter #4
Sorry for the late Thank You but Thanks,I really do apprechiate it.Off to the shop to get it made.
 
1 - 4 of 4 Posts
Top