Ford Muscle Cars Tech Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
134 Posts
Discussion Starter #1
I need to get to the rear P.W. motor hardware on a 2 door 61. Before I go out there pushing pulling or searching for bolts, how does the lower rear bench seat come out? Is it like GM and push like hell down and towards the back or?
 

·
Registered
Joined
·
194 Posts
You should be able to push the lower rear bench back and down a bit towards the rear of the car and once it clears the two bottom holders then pull it up and towards the front of the car to remove it.
 

·
Registered
Joined
·
134 Posts
Discussion Starter #3
Thanks. I wasn't sure. The frame sets so close to the floor, it doesn't look like there is any room to press it down. My GM cars have an inch or so gap. I'll give it a try.
 
1 - 4 of 4 Posts
Top