Ford Muscle Cars Tech Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
110 Posts
Discussion Starter · #1 ·
If I was going to do the heads on my 302....could someone explain what extra effort would be needed to replace the cam. (this would be my first time) How difficult? Thanks for the replies....The more defined and better explained....the better.

Allan
 

· Registered
Joined
·
110 Posts
Discussion Starter · #3 ·
How difficult is it to put a new cam in. How do you line the lobes and everything up? The bearings should be still good because the engine was rebuilt about 2.5 years ago. Thanks
Allan
 

· Registered
Joined
·
110 Posts
Discussion Starter · #5 ·
how is it that the cam will fall in same place as the old one....and how do you replace the timing set without changing timing off....?And how tight do you tighten the rocker arms down...
sorry for the dumb questions...

Allan
 

· Registered
Joined
·
110 Posts
Discussion Starter · #13 ·
Thanks guys....I want to try to do this over the summer. I will look at every site you give me. Timing gears,chain, cam, valves, and crap is the things I dont understand the most. Thanks again for all your help.
Allan
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top