Ford Muscle Cars Tech Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
169 Posts
Discussion Starter #1
When my motor got disassembled, one of my cohorts in crime just dumped all the lifters in a bucket... Same with the pushrods.

I was gonna put the stock cam, lifters, and pushrods back in the motor, but I'm getting some new roller rockers.

Should I expect problems with this? I'm sure I'll never figure out where each lifter originally came out. There doesn't seem to be any wear on either the cam or lifters. I hope it doesn't matter too much.
The engine had 144,000 miles on it when I tore it down.

1989 5.0 HO Mustang motor, came stock with roller lifters.

<font size=-1>[ This Message was edited by: SawBones25 on 1/23/02 12:22pm ]</font>
 
1 - 2 of 2 Posts
Top