Ford Muscle Cars Tech Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
When I bolt my pressure plate to the flywheel. One of the three fingers is not at the same height as the other two. It is about .075" lower and it is a little loose. Can the fingers be adjusted? What could be the problem? I don't want my throw out bearing ruined or the clutch wearing wrong.
 

·
Registered
Joined
·
3,700 Posts
I noticed mine had somewhat "loose" fingers as well ...

Under a tenth of an inch doesn't seem to far out to me especially if the finger is a tad loose to boot ...

My clutch is working flawlessly after reassembly and I have no concerns based on what I have here ...

But your post does remind me of my concerns a little

_________________


<font size=-1>[ This Message was edited by: MonsterMach on 6/28/06 9:29am ]</font>
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top