Ford Muscle Cars Tech Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
395 Posts
Discussion Starter · #1 ·
I got a '91 MAF Harness and computer to go into my '87. Started to make the swap and found that there are 2 plugs over by the windshield wiper motor where the new harness has only one plug. Also the old harness has some kind of large balast reisitor in the same location.

What do I need to do to finish the swap? Will everything work properly if I leave that other plug open?

<font size=-1>[ This Message was edited by: Ronbuell on 3/13/06 9:43am ]</font>
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top