Ford Muscle Cars Tech Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Out of the endless number of lower control arm choices out there, I am leaning the most towards picking up a set of the Megabite Jr. lowers and non-adjustable uppers. After engine work, I am anticipating high 11's and want some bars that will 60 foot well on 10 inch slicks. Anybody have experience with Megabites or Trz? Does anyone have the opinnion that there is a better choice than these two?
 

·
Registered
Joined
·
1,929 Posts
I boxed the stock control arms on my 85 GT. I also used the urathane bushings. Plenty good for an 11 sec. ride. Mines run a best of 11.53 with low 1.50's at 60 ft. Reworked stockers work just fine.

<font size=-1>[ This Message was edited by: 85Mike on 3/23/02 9:39am ]</font>
 
1 - 2 of 2 Posts
Top