Ford Muscle Cars Tech Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
2,163 Posts
Discussion Starter #1
Here's Bob's car. These are the only one's he sent. I guess it's to cold outside and doesnt want the car cold.



_________________

68 Fairlane/70 Cougar

<font size=-1>[ This Message was edited by: dark7068 on 1/22/02 1:56pm ]</font>
 

·
Registered
Joined
·
521 Posts
Thanks Dark couldn't of done it without you.
Just a little bit about the car :
1968 mustang GT coupe
466 big block
holley 850 dp
weiand stealth intake (ported)
cast iron heads (ported and polished) bigger valves
ultradyne rollercam
crane gold race 1.73 roller rockers
speed pro forged pistons and rings
canton 8 qt oil pan
TCI full manual reverse valve body C6
denny's chromemoly 3 inch drive shaft
2inch crites headers jet hot coated
3 1/2 inch exhuast Dr.Gasx crossover
flowmaster mufflers
rear end is waiting to be finished
roll cage soon to be installed
6 inch cowl induction hood
fiberglass deck lid
car will be painted silver with black C-stripe
15x8 and 15x6 weld rodlights
275 60 15 BFG drag radials
 

·
Registered
Joined
·
456 Posts
Hey Bob!
What manufacture did you get your hood from? Are you happy with the fit and finish? Looks good on your car. She ought to really run!
 

·
Registered
Joined
·
521 Posts
The hood is unlmited products and I'm not really happy with the hood.the rear where it meets the cowl doesnt line up and it need alot of sanding to get it smooth.I also have their fiberglass decklid and it stinks also.too late to send it back so I guess i'll just have to put some time in it to get it right.
Their products definately dont reflect what they advertise.
 

·
Registered
Joined
·
521 Posts
The hood is unlmited products and I'm not really happy with the hood.the rear where it meets the cowl doesnt line up and it need alot of sanding to get it smooth.I also have their fiberglass decklid and it stinks also.too late to send it back so I guess i'll just have to put some time in it to get it right.
Their products definately dont reflect what they advertise.
 

·
Registered
Joined
·
456 Posts
Thanks Bob. I was hoping to find someone who had a cowl hood that was happy with it. Does anyone know where I can find a quality cowl hood for a 67 Stang?
 

·
Registered
Joined
·
521 Posts
I would talk to drag79stang he seemed to be pretty happy with his new hood and it looks great.I believe it was from Glastek.
BOB
 
1 - 12 of 12 Posts
Top