Ford Muscle Cars Tech Forum banner
1 - 16 of 16 Posts

·
Registered
Joined
·
1,506 Posts
Discussion Starter · #1 ·
What's the name of that tool I'll need to hold the flywheel as I loosen the torque converter bolts?
 

·
Registered
Joined
·
1,506 Posts
Discussion Starter · #5 ·
In other words, you're telling me that I can use a screwdriver or socket extension instead?
I have no idea what the hell a bottle jack handle is....
 

·
Registered
Joined
·
335 Posts
I actually use a steerign wheel puller/balancer puller. The hollow cross looking part. I put a bolt in one enad and thread it to the block somewhere and the other end either bolts to an existing threaded hole in the flywheel or a through bolt and nut if on flexplate. Very simple!
 

·
Registered
Joined
·
1,506 Posts
Discussion Starter · #12 ·
On 2006-03-31 05:43, mavman wrote:
Impact wrench. Jeez, was it that hard?
If I had air tools, I wouldn't be asking......
 

·
Registered
Joined
·
3,692 Posts
On 2006-03-31 06:51, FEandGoingBroke wrote:
You guy's are WEAK....


I use my hand....
I don't want to know what for.


<font size=-1>[ This Message was edited by: 1 Bad 88 GT on 4/1/06 1:06pm ]</font>
 
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top