Ford Muscle Cars Tech Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
i just did a rebuild with a B&M rebuild kit with shift kit. and all i have is first gear. it wont shift to 2nd and no reverse. all the air checks seem fine, getting a good thud on clutch packs and servo's are good and governor. my reverse high clutch is .056 and forward clutch is .029 and end play is .032 inter. band is at 1 1/2 turns and low reverse is 3 turns. anyone have any ideas on what could be wrong. ive also been back through the v/b and everything seems ok in there.....anyone have an idea what my prob is????????
 

·
Registered
Joined
·
861 Posts
Reverse uses the direct clutch and rear band.

Do both of these apply strongly?


You may have to go through the valve body.

B&M? Did you use a separator plate gasket?
 

·
Registered
Joined
·
15 Posts
Discussion Starter · #3 ·
yes i did an air check several times just on the stator and in the case and the the bands hold tight. i believe it is a trans go kit, it all came in a B&M box that i ordered from summit racing. the valve body was the first thing i check and i did find acouple things in there that i meesed up on but after fixing them and putting back together i still had no reverse and no i didnt take it out to see if it would shift since i still had no reverse.
 
1 - 3 of 3 Posts
Top