I know this has been asked before, but has anybosy really used the Hooker #6208 1 3/4" 351 header in a 64-65? I know the Tubular Automotive ones fit nice, but I can't see using 1 1/2" headers on a 351 stroker with AFR heads. Thanks
yes I have they are a tight fit I you have the styds sticking out for the upper control arms you need to cut them flus with the nut if not you will be denting to tube and its bad enough have restrictive they are new
i was thinking that same question because i am looking for some 1 3/4 headers for my 65 falcon 355 stroker with stage 2 ported victor jr. heads and 590 lift came with 244dur at .50" so i wanted to make the most power possible.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.