[rjhauver]

Was finishing a 460 swap into a 66 2dr sedan and I ran into a slight problem. The car was originally a 289 auto and I knew I was gonna need a slip yoke for a C6, so I figured I could use the one from my pop's '67 Ranchero (390AT) as he's changeing it over to a 5.8 AOD setup. No sir. It has a 3 7/8" Yoke, while my driveshaft is 3 1/2". Like an idiot, I already had my driveshaft shortened, so where can I locate a 3 1/2" slip yoke for a C6. Or am I screwed? Any suggestions would be greatly appreciated. I just wanna finally get this thing on the street!

 

[107485]

not sure but you should repost this in the main tech forum for more answers...good luck

 

[rjhauver]

Just called napa and they suggested a combo u joint. Not sure if its the safest application, but it might work if they have one. Gonna head down there tomorrow to check it out (just closed up today). If nothin, I'll repost in the tech forum tomorrow. Thanks for that. Just started using these forums and didn't know the proper place to post. Preciate it.