Ford Muscle Cars Tech Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
780 Posts
Discussion Starter · #1 ·
I am having my Performer RPM intake runner ported and balanced by Panhandle performance. Does anyone have any feedback on Panhandle to port intakes?
 

·
Registered
Joined
·
1,068 Posts
they ported my roush 200's. they did a great job. great customer service too. I would bet that your intake turns out very nice.
 

·
Registered
Joined
·
780 Posts
Discussion Starter · #5 ·
Thanks for the input, great to hear the compliments on panhandle. I hope they can achieve some good flow numbers on my RPM runners.
 

·
Registered
Joined
·
780 Posts
Discussion Starter · #7 ·
Thanks They are shipping the intake today. 351W Performer RPM flows 280-286CFM per runner. Should be a great improvement over the stock 230 CFM.
 

·
Registered
Joined
·
738 Posts
Alan
Let us know how it turns out, shaker cars are pretty much limited to the RPM. Been thinking along those line too, or extrude honing it, just a little $$$.
if you don't mind how much coin did the surgery set you back?
 

·
Registered
Joined
·
780 Posts
Discussion Starter · #9 ·
The Performer RPM intake and stage 1+ was 595. I opted to get a new intake so I could run my car in the meantime. I nixed the extrude hone idea. I'll let you know how it works.
 
1 - 9 of 9 Posts
Top