Ford Muscle Cars Tech Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
242 Posts
Discussion Starter #1
I am porting my D0OE heads and need to know how much should or can I grind out in the intake ports were the pushrod runs through them??
 

·
Registered
Joined
·
231 Posts
Make sure that you leave at least .060 of material between the port and the pushrod hole. That's approx 1/16th of an inch. There's a simple tool called the Helgesen E-tool that's available from Dr Air (714-535-5748 that's made for measuring pushrod tube to port distance. It's very simple and shouldn't be a lot of money.

<font size=-1>[ This Message was edited by: mach1morgan on 1/19/02 7:36am ]</font>
 
1 - 3 of 3 Posts
Top