Proform HEI Distributor Review
Join the discussion
Recommended Reading
-
Ignition issue
Ignition ArticlesI have a 1965 F100 with a 1983 302 engine and duraspark ignition. I have an issue that started recently that when I start the truck and release the key to run the engine stalls and will only run when I hold the key toward start. I replaced the duraspark ignition 12A199a and was told that would...- 0
- 245
-
Ignition resistor wire removal 1973 torino
Ignition ArticlesI finally got around to upgrading my factory points ignition in my 73 torino 351w. The Accel electronic distributor I picked needs full 12 volts instead of the 7-8 volts the points require. So I got out the factory shop manual wiring diagram and went to town. You have to remove the cluster, we...- 19
- 27K
-
Troubleshooting your ignition system
Ignition ArticlesIf your vehicle won't start and you know that it is not a lack of fuel or a lack of air, then ignition must be the problem, but where in the ignition system is the issue? What part of the ignition is not doing its job, and how do we find it???? Welcome to the second half of a two part series...- 19
- 161K
-
Running Points With a CD Ignition Box
Ignition ArticlesThere are numerous choices when it comes to choosing an ignition system for your vintage Ford. You could go all out right off the bat and buy a billet distributor from any number of aftermarket parts manufacturers along with a capacitive discharge (CD) ignition box that could light off a small...- 14
- 18K
-
Fox Mustang MSD 6AL Install
Ignition ArticlesAll of this is in the quest of turning my once-stock 1990 Mustang LX into a fun little street/strip car. In past installments, I have: 1. Swapped the stock T5 for a C4: http://www.fordmuscle.com/forums/transmission-articles/483478-fox-mustang-t5-c4-swap.html 2. Installed a driveshaft loop...- 5
- 35K
Join now to ask and comment!