Ford Muscle Cars Tech Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
Hey guys, I'm about 85% done with a restore on a 67 galaxie fastback and am at the brakes stage. The lines in the car are good, were replaced by the previous owner about 7 years ago. What I've done is gone to four wheel disk and am getting ready to tie it all together. My problem is this: there's a single hard line running down the driver's side frame rail that ends at a point just above the rear differential. From there I have no idea what happens. I imagine there's some sort of tee union that this hard line hooks up to that my caliper's soft lines can plug into, but I don't have anything here and I don't think there was anything there when I bought the car, at least if there was I don't remember it and its long gone. I'm running 3/16" hard line from the master cylinder to the rear.

Any ideas on how this should go together? I'll try to post a pic later...
 
1 - 2 of 2 Posts
Top