Ford Muscle Cars Tech Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
210 Posts
Discussion Starter · #1 ·
Hi everyone
I have a set of Roller Rocker for my 351c 2v
I was going to wait to install them in a new head built head
but I'd really like to use them
Will there be a problem installing them now then later installing in the new
head ?
 

· Premium Member
Joined
·
3,980 Posts
Hi everyone
I have a set of Roller Rocker for my 351c 2v
I was going to wait to install them in a new head built head
but I'd really like to use them
Will there be a problem installing them now then later installing in the new
head ?
No issues, they are reusable, but as stated, geometry may change requiring different setup, but won't hurt the rockers

However, if changing ratio with the swap now, be sure to look at coil bind and seal clearance as a minimum
 

· Registered
Joined
·
7 Posts
Hi, I need help, I’m going to buy new cylinders heads for my 76 302 (FT) and the sellers has two different packeges one for hyd flat tapers and the other for hyd rollers, they are exactly the same except for the intake, I want to buy the one that’s says is for rollers cause it has a single plane intake, and the FT one has a doble plane intake, is there Amy major difference in the heads between flat tapers and rollers???? (The package doesn’t include pushrods or tapers, I’ll leave some Pic so you can see what I mean, thanks)
Font Auto part Engineering Machine Electronic component

Font Auto part Engineering Electronic component Machine
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top