I have a brand new but never installed kit from RRS to convert your '68 or '69 Torino to rack and pinion steering. I purchased it back in 2010 but never had the time to install it, so it sat in the garage mostly wrapped up.
It's completely new except there's some light surface rust on the unpainted tie rods, and the bearing that goes inside the steering column sat in some water for a bit, but the damage is only cosmetic and it's not visible after installation.
I paid $2300AUD for it back then, which was about $2100US. I'm looking to get $1,000US for the kit as it stands plus shipping, which I expect to be $150US.
It's completely new except there's some light surface rust on the unpainted tie rods, and the bearing that goes inside the steering column sat in some water for a bit, but the damage is only cosmetic and it's not visible after installation.
I paid $2300AUD for it back then, which was about $2100US. I'm looking to get $1,000US for the kit as it stands plus shipping, which I expect to be $150US.
Attachments
-
217.6 KB Views: 174
-
213.4 KB Views: 187
-
198.4 KB Views: 143
-
224 KB Views: 138
-
222 KB Views: 141
-
222.8 KB Views: 159
-
202.8 KB Views: 162
-
225.9 KB Views: 136
-
223.4 KB Views: 183
-
226.1 KB Views: 172
-
200.4 KB Views: 126