Ford Muscle Cars Tech Forum banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
684 Posts
Discussion Starter #1
Is a 1976 Torino door skin the same as a 1976 Elite? Are the doors dimensions the same for the two "models"?

They were basically the same car. I know the rear quarter panels are not the same just from looking at Torino's over the years. I'm getting ready to start some cancer repair on my car and Torino's are a lot easier for parts folks to relate with than an Elite. Any help is appreciated.
 

·
Premium Member
Joined
·
684 Posts
Discussion Starter #3
Thanks DT!!
I was hoping against hope the Ford Gods were smiling, but I should know better than to think the obvious model's sheet metal would interchange. That's just not Ford's way.

I guess I'll keep looking. My brother told me to get a used dryer and cut the patches out of it. I will do so if necessary, I was just hoping to find something pre-formed. I'm lazy like that.
 
1 - 3 of 3 Posts
Top