Ford Muscle Cars Tech Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,187 Posts
Discussion Starter · #1 ·
Six Deuces

Couple years ago I sold off an Edelbrock intake manifold which was set up for six Stromberg 94 carburetors. As it was of the early design for the FE engines, I had to do some swapping around of heads, water pump, etc. in order for it to fit correctly onto my A.J. Foyt 427 block. Another big block lover found an advertisement of the manifold in a Honest Charlie catalogue of about 1960. It was about the most expensive intake they had indicated in there too.

What we were wondering is that was this same or similar manifold available for the slightly later FE engines? Those w/o the spring loaded camshshaft.

Wm.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top