solid cam lift specs

730 Views 2 Replies 3 Participants Last post by 289nate, Feb 23, 2006

Discussion Starter · Feb 23, 2006

when a cam manufacturer lists a sold cam, say with .500 lift, and a valve lash of .020hot, would the actual lift at the valve be .480?

1 - 3 of 3 Posts

yes

They also measure the duration at the lobe and not the valve. So your .050 duration (at the valve) will be a few degrees smaller as well.

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.