wanting to put a valve body in my 1989 mustang gt but with the trans thats in it i only have 1st drive and over drive so how do you go about putting a good valve body in it and get your 1-2-3 shifts with out going into overdrive. i was also told that the car will pick up et by doing this up grade to trans.
trans questions
Join the discussion
Recommended Reading
-
Fox vs Sn95 5.0 donor
Mustang Pages (1979-1995)Hey guys, I have been researching a lot on which mustang motor I want to get as a donor for my 1951 Ford f1. I have decided on an efi 5.0 with MAF, and been leaning heavily to the 89-93 models. My goal has been to find a wrecked car to pull the motor and trans from (1- cheaper, 2- I can't kill...- 0
- 534
-
Questions on 351w build
Mustang Pages (1979-1995)I traded my falcon I had for an 82 Mustang GT that had a 351w in it. The kid lost bearing messed up crank and took chunks out of bottom of cylinder walls. Guessing that block is **** now. I have another engine that I am going to be getting looked at and checked out to see if useable. The car ran...- 4
- 1K
-
1991 2.3 dsi swap in a 1988 mustang
Mustang Pages (1979-1995)I am new to this site and could use some help on a build I started. I have a 1988 convertible 2.3 auto very low miles and very clean. Only problem is a bad engine. I have a 1991 2.3 8 plus engine and I need to know what wiring issues I will have. I have the harness and computer are there any...- 0
- 333
-
302 Based Street Flow Header info
Mustang Pages (1979-1995)Anyone running Street Flow hi port heads from the mid 90's? If so what headers are you using? Thanks!!- 0
- 458
-
How much power will it make
Mustang Pages (1979-1995)I have a 1995 cobra block just a stock 5.0 roller block that's been prepped bored .30 over now is a 306 cid with je pistons for 13.0.1 compression 4340 forged rods with 7/16 rod bolts good for 1000 hp @ 8200 rpm I know I will not make that power but still over kill is better then not enough...- 0
- 627
Join now to ask and comment!