[EXracer4speed]

Anyone have a fork layin around? Toploader with 1 3/8 input. Thanks

 

[RAGGAREN]

go here....

JEGS Performance Products 601151 JEGS Heavy Duty Clutch Forks

 

[63ford406]

David Kee Toploaders in TX.

 

[EXracer4speed]

Thanks!!

 

[RAGGAREN]

David Kee Toploaders in TX.

Clutch Forks

 

[Mroldfart2U]

Didnt know if he just needed a fork, or if he needed the big fork cuz his was a small one... there is a tech article about doing a big shaft conversion to a small shaft fork in the tech section..... cant remember who did the write up tho, been awhile sense i saw it... But glad someone pointed you the right direction..



ADD AFTER FACT: Dennis111 was the author of article.

 

[63.5xl]

I also need a big input clutch fork for a 64 Galaxie. I called david kee and thy do not have one for the galaxies. I called Mcleod and they said it was #16935 but i read somewhere else theres is not right for the Galaxie

 

[Mroldfart2U]

I also need a big input clutch fork for a 64 Galaxie. I called david kee and thy do not have one for the galaxies. I called Mcleod and they said it was #16935 but i read somewhere else theres is not right for the Galaxie

Do you NOT have a fork at all or just need it to fit the Big Shaft? IF you have one check HERE. All you would need is ANY big shaft fork and YOUR small shaft fork.

 

[63.5xl]

I just got off the phone talking to Dan Williams at toploadertransmissions.com and he said he could stamp one out in no time if he had an original one to go by. If anyone has one they can give up for a couple of days give him a call, and we could all benefit from it. He says he get calls for one all the time but nobody has sent him one yet so he can stamp them out a very resonable cost. Dan Williams business #
828-524-9085
toploadertransmissions.com

 

[EXracer4speed]

63 I just spoke to another ford specialist here in nj and your 100% correct. The fork is apparently almost straight with little bend. He gave me a lead out in Michigan and am waiting on a call back.