[hotmaverick302]

I need one set that fit afr 205 heads, 2,08x1,60 valve and .610 lift.
Any help, all that i look fit 2,02x1,60 valve, and i dont apreciate custom made pistons (very espensive, $$$).

 

[coolfalcon]

Hand clearance the ones you have. Do a mock up check to see where they will hit nice and easily turning the motor over then hand grind the obstruction out. I did that to mine because I didn’t like the final clearances at final assembly.

 

[mstngjoe]

FWIW, I'm using a piston from Probe.

www.probeindustries.com

 

[tonys10sec306]

they should clear

 

[gorgan1314]

The techs at KB told me the kb115 and kb116 can take a 2.10 valve.

 

[hotmaverick302]

KB tod me the all pistons cam take a 2,02 valve (kb736, kb 719, kb281, kb116)

 

[mavman]

My 302 in the Mustang has 2.02 valves. They are VERY close to the edges of the reliefs with the KB116's.

I HAD a set of SRP flat tops listed in the classifieds a while back, but I don't know whether noone wanted a set of used pistons for $100 or noone reads the classified section.....but I junked them. Yes, I took
them to a scrap metal recycler and got a whole $3 out of the set.

Check out SRP (a division of JE pistons) and Mahle. Both make excellent quality stuff and they're fairly inexpensive compared to custom piston$.

 

[smokey212]

How much are you looking to pay for them. I had a set of custom pistons made from brc performance, and they were very nice. They have a -21cc dish to keep compression right at 10.8.1 on my 414w. With a 4.00 stroke and 6.2 rod.