[Weldin810]

Attached is a photo. I want to put an alternator on my car, its a 351 windsor. I need a pulley for the crank, alt bracket, alternator, alt pulley, belt..

But where do i get these for this generic set up? I dont need ac or water pump pulley. Can i get just a single belt pulley for my engine? if not i'll use whatever but what do i look for/ask for at a salvage yard? will any pulley & alt bracket work from any vehicle that used a 351 windsor? what about the 351c, will pulley & bracket work?

I dont need or even want something pretty & polished.. affordable & appropriate for my set up is all i need. I want to make this strip only car into a street & occasional strip car.

 

[Mroldfart2U]

Weldon by the pic, yes you can use a 4 bolt pulley from anything that uses the 4 bolt. (some were 3 some were 4). Cant tell ya what to ask for as far as just asking, if ya have a pick a part be better just to do the hunting yourself. Check this thread, it has a pic of the brackets needed....http://www.fordmuscleforums.com/str...ternator-crankshaft-belt-drive-kit-347-a.html

 

[dennis112]

Look for 1970 or later 351w only (avoid 1969.) Its best to get all the parts off of 1 single motor as there are different variations used throughout the years. Can be truck, van or car. You might want to specify no AC or PS, although they may be the same. Later years will have a wide cogged belt.