Ford Muscle Cars Tech Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
202 Posts
Discussion Starter · #1 ·
I am lookin for someone that can do a full port job on some aluminum heads with a flow sheet b4 and after....You guys have any suggestions?
 

·
Registered
Joined
·
202 Posts
Discussion Starter · #3 ·
brodix heads and id spend about $1k
 

·
Registered
Joined
·
3,658 Posts
Most people I know port heads with die grinders.

Flow sheets would wear out too fast.


But other than being a smartass, I don't know of anyone
 

·
Registered
Joined
·
522 Posts
XSR Cylinder Heads!! There on the internet.


<font size=-1>[ This Message was edited by: ran347nosgt on 11/28/06 11:07am ]</font>
 

·
Registered
Joined
·
377 Posts
Well, I do. If you want a cnc job, TEA is the only place I would go. If you want hand porting, that's what I do. I have a superflow 600 bench, and 17 years experience porting and engine building. We have a DTS dyno coming in Jan, and full machine shop here in SoCal. Check out my website:www.immengines.com
Brian
 

·
Registered
Joined
·
5,551 Posts
Keith Craft, Kuntz & co., MPG heads, TEA, FTI, Chapman racing, Mikes porting service (mikesportingservice.com), busch racing (from HC5.0), Ford performance solutions, Joe Scherman (who is having some port work done on himself as we speak....the ol' ticker is getting a port job), Coast High Performance, and many, many others. Just do some searching and you'll find most of the info you need.
 
1 - 12 of 12 Posts
Top