Ford Muscle Cars Tech Forum banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
401 Posts
Discussion Starter · #1 ·
I am going to stroke my FE 390 to a 431, put in a nice Comp roller cam and lifters, with Harlan Sharpe rockers. I want to feed the beast with dual 500 cfm quads like Edel.'s Air-gap matched set. Will this fit under my stock hood?
 

·
Registered
Joined
·
5,337 Posts
EDELBROCK has on it's site the method to measure carb pad height on differing intakes.
 

·
Premium Member
Joined
·
401 Posts
Discussion Starter · #3 ·
EDELBROCK has on it's site the method to measure carb pad height on differing intakes.
On that note, will I need to figure out what my stock clearance is to my hood off a stock "S" intake? or does anyone have that information in an old tech manual somewhere? Curios.. Thank you :)
 

·
Registered
Joined
·
5,337 Posts
Use same method shown in the ATTACHED.

EDLELBROCK lists the pad heights of it's intakes.
 
1 - 5 of 5 Posts
Top